Introduction
Top Toolbar and Preset Browser
Semi-Normalled Patching
Voltage-Controlled Oscillators
Voltage-Controlled Filter
Voltage-Controlled Amplifier
ADSR and AD Envelope Generators
Master Section
Preamp and Sidechain Input
MIDI Control
Noise Source
Voltage Processors
Sample & Hold and Electronic Switch
Low Frequency Oscillator
Effects
MIDI Controllers Setup and The MIDI Tab
QWERTY Musical Typing Keyboard (MTK)
Settings
Master Tune- Sets master tuning up or down by a half-step.
Master Volume- Sets CA2600 master volume.
Output Meters- Not really a control, but this displays the master output. Like any other meter, it's best to keep these out of the red.
Pan- Adjusts the position of the dry VCF and VCA outputs between the left and right channels. This is useful if for panning the dry vs. effected signals.
Master Input Mixer
The Master Section's inputs jacks and faders are the final output mixer. As with CA2600's other sections, the orange boxes beneath the faders indicated the normalled input routings, and can be overridden with patch cables by plugging into the jacks above them.
Mixer Upper Output jacks- The jacks above the faders are outputs. Their levels are affected by the fader amount. They do not break the signal flow to the master output bus; think of them as extra points to tap signals for further routing and mangling.
The table below shows the filter's default sources and destinations.
|
AUDIO INPUT NAME |
NORMALLED SOURCE |
NORMALLED DESTINATION |
|---|---|---|
|
Master Out/Audio Input - VCF |
VCF output |
master out bus / L/R pan slider |
|
Master Out/Audio Input - VCA |
VCA output |
master out bus / L/R pan slider |
|
Master Out/Audio Input - Dist |
distortion effect output |
master out bus / FX bus |
|
Master Out/Audio Input - Del |
delay effect output |
master out bus / FX bus |
|
Master Out/Audio Input - St Verb |
reverb effect output |
master out bus / stereo FX bus |