The Voltage Modular Miniverse Oscillator super accurately replicates the famously brawny sounds of the original Mini.
Inputs, Outputs, and Controls
Range- Sets the pitch range for each oscillator in octaves. These are at standard organ footage settings of 32', 16', 8', 4', and 2', as well as a Lo sub-audio setting.
Waveform- Allows selection of oscillator waveforms, including triangle, triangle/ramp combo (aka, "shark tooth," ramp, square, wide pulse, or narrow pulse.
Pitch CV- Accepts a 1V/octave CV input for pitch. Typically this would come from the Pitch jack in the IO Panel CV Out section, or from a sequencer pitch CV out.
Frequency- This can be used to fatten up two oscillator patches by detuning a small amount, or for "building-in" a set interval. Its range is a smidge over a fifth, up or down.
Modulation inputs 1/2 jack and attenuverter- These are used for externally modulating the oscillator frequency. They're useful for adding vibrato, siren noises, envelope-controlled pitch sweeps, etc. The mod amount knobs are bipolar- center position is off; turning the knob to the right applies positive modulation, and turning to the left applies negative modulation.
Signal Output- The oscillator output signal.